MOPLY N PLUS 2 KG AL

Start

Start

MOPLY N PLUS 2 Kg AL membrane without reinforcement, finished with an aluminium in its upper layer and thermally bonded film in its lower layer, with low temperature plegability of ≥ -10 ºc.

Technical documentation

Advantages
Application
Installation
Storage
Regulations

· A mastic with plastic features that allow for easy placement and handling.
· Better performance at high temperatures and better flexibility (-10ºC), provides the membrane with a slower ageing process.

Can be applied as upper layer in multi layer systems.
Single layer application not recommended.
Self-protected membrane.
Heavy topping not required.
Application: Torch-on

· SUPPORT: The surface must be dry, firm, even, clean and free of loose materials.
· It can be applied completely adhered to the support or the base membrane
· To adhere the membrane to the support, the support is primed with EMUFAL I or EMUFAL L. Once dry, use flame to adhere the membrane.
· The flame is applied as uniformly as possible (the greater the heat, the greater the retraction) along the width of the membrane without reaching the overlap, which will be done later, since it is important that the temperature be the same in every area. The flame should be applied until the anti-adherent film pore opens.
· The membranes are installed in such a way that no more than three membranes overlap at the same point.
· Overlaps are flame-bonded, with a minimum overlap of 8 cm.
· The top membrane must be completely adhered to the bottom membrane, and it must be placed in the same direction and so that the overlap lays approximately in the middle of the bottom membrane.
· Installation and measurements will be conducted in accordance with european regulations and the Texsa application guide.

Roll 1 x 15 m
Pallet 450 m²

· In accordance with the EN 13707 standard. Certified with CE marking No. 0099/CPD/A85/0087
· Quality System in accordance with ISO:9001

Site Map Legal Notice

DATA PROTECTION

In cases where the user must provide data of a personal nature to TEXSA SYSTEMS SLU to use any of the Web services, the former will be expressly informed each time of the existence of an automated data base, the aim of same, those receiving the information and identity and address of the person responsible for data treatment, all with the aim of complying with that stipulated in Organic Law 15/1999 of 13th December, for the Protection of Data of a Personal Nature. To this effect, TEXSA SYSTEMS SLU shall reserve confidentiality of the data obtained and the users can exercise all rights to access, amendment, cancellation and any others referred to in aforementioned Organic Law 15/1999.

TEXSA SYSTEMS SLU has adopted all the necessary measures of a technical and organisational nature, to guarantee the security of the data of a personal nature, with the aim of preventing their alteration, loss, treatment or unauthorised access, in accordance with the requirements and conditions called for by Royal Decree 994/1999 of 11th June, in which the Regulation of safety measures of automated files containing data of a personal nature, is passed, notwithstanding the user's acceptance and knowledge that to date totally impregnable safety measures do not exist.

In case of doubt or the need to extend the information covering any of the above items, please do not hesitate to contact TEXSA SYSTEMS SLU.

TEXSA SYSTEMS SLU.
C/Ferro Nº7,
Polígono Industrial Can Pelegrí,
Castellbisbal
08755, Barcelona - Spain
NIF B66067687

Tel. (+34) 93 635 14 00
Fax (+34) 93 635 14 80

Email: lopd@texsa.com

Site Map Legal Notice